Struggling with a staircase.

[Richard Birket]

I am pretty sure RailClone could generate this staircase, but my knowledge is not yet that extensive. Is this something anyone from itoosoft could help me with if I were to supply drawings? Do you think railclone could generate the geometry?

Attached is a screengrab of the autocad drawings I have.

[iToo]

Yes, i think it can be done, but this staircase probably would require several hours of work.

What about if you create the basic elements in Max, and we help you to compose them using RailClone ?

[Richard Birket]

Thankyou Carlos. In the end, I managed to create the staircase (allbeit approximately) within AutoCad using the Loft tool. I think RailClone wuold do a better job of it, but I just had to go with what I knew in this project.